The Bullet Board

I need the coil side, male, of the 2 wire connector. It connects the coil wires to the ignition. RE uses some unique plugs. Where can I get the male side, or a male/female set?
I'm setting up the coil to interface with a PCV equipped CGT 535.
Bill G.

Maybe Tim at Western Cycle Supply might have them?

I sent Tim an email. We'll see. This is a 'junk yard' type of part. They ought to be around. As we know RE likes to use the unique in the world Indian bits. I've looked on eBay and amazon and I don't see a simple source of a common item.
I got the idea to get my own blades and attach them to the coil wires. Stick in the blades into the female. Then use some shrink tubing to close them up.

I found out the RE plugs are made by Sumitomo. I've got some on order. Who knew?

Guaire wrote: ↑Sat Nov 19, 2022 3:14 pm I found out the RE plugs are made by Sumitomo. I've got some on order. Who knew?

Can you share the plug info for the archives?

"These connectors are identical to the Sumitomo MT 090 2 pin connectors and should be easy to find them on eBay."
I pasted "Sumitomo MT 090 2 pin connector" in an eBay search and found them. They will arrive this week.
Also, here's the pic of the stock UCE coil that includes the male plug.
I will post the eBay URLs, but they might change.
https://www.ebay.com/itm/264512095303

https://www.ebay.com/itm/255518187771
Bill G.

Looks like some connectors will arrive tomorrow, Wednesday Nov. 23 via eBay. Yesterday I got the shorter pair of cylinder bolts. On the intake side I reduced the height to 0.17". It fits under the rocker arm with a little bit of clearance.
This week I can get the coils going.