A Royal Enfield forum for the people

[Tim]

I know the 2009 has the 1st gen turn signal connectors. They were changed in 2010 with the new wiring harness. What I don't know is what type they are?

I am going to be putting stock connectors on aftermarket turn signals. I personally hate cutting into a harness, I think other people will appreciate the convenience as well. Does anyone have connectors that don't look like this?

OBF if you want to sit this one out I won't be offended

[OlBilford]

No one? It looks to be the same...stylistically anyway..

[Tim]

I think these are what I am looking for.

[OlBilford]

Well...I was wrong upon lookin..shows you to listen to me..hahah

[gashousegorilla]

No one? It looks to be the same...stylistically anyway..

I wouldn't have paid that much attention to it ? ... Haha ! I would have just nipped off what ever plug was there and use heat shrink bullet connectors to put the wires from the new light to the harness.

[Tim]

I wouldn't have paid that much attention to it ? ... Haha ! I would have just nipped off what ever plug was there and use heat shrink bullet connectors to put the wires from the new light to the harness.

Sure, you can do that but wouldn't it be convenient if you didn't have to Plus this is intended for the folks that don't rebuild top ends for fun

[gashousegorilla]

I wouldn't have paid that much attention to it ? ... Haha ! I would have just nipped off what ever plug was there and use heat shrink bullet connectors to put the wires from the new light to the harness.

Sure, you can do that but wouldn't it be convenient if you didn't have to Plus this is intended for the folks that don't rebuild top ends for fun

Hehehe ! This IS true I must admit. .. Haha ! Here Tim, check this guy out . He may have some stuff your looking for....

http://www.oregonmotorcycleparts.com/connectors.html